by Nathan Frey | Jun 24, 2020 | Air Filtration, Tech Tips
HEPA air purification systems are often misplaced in dental offices and labs. Use this guide to properly place your HEPA air purifier. Dental staff and equipment dealers are rarely educated on the nuances of where to place air filtration devices in dental...
by Nathan Frey | May 7, 2019 | General, Tech Tips
While there are many aspects to designing an efficient dental lab, proper suction design for dust collection is often overlooked. Keeping your work stations and lab area clean are highly important and without adequate dust collection, your lab can quickly become a...
by Nathan Frey | Aug 15, 2018 | General, Tech Tips, White Papers
Looking for an ultimate guide on conformal coating removal? We’ve compiled all the latest technical resources and standards to make your next PCB rework and repair job a breeze whether you’re working with Silicone, Epoxy, Parylene, Acrylic, or Urethane....
by Kyle Galenza | Oct 10, 2014 | Tech Tips
This guide will help you use abrasive blasting to remove coatings from PCB’s and circuit boards. In particular, how to remove parylene remove various coatings, including conformal coating with abrasive blasting using a sandblaster. if you’re looking for...
by Kyle Galenza | Oct 6, 2014 | Tech Tips
Customers occasionally inquire about the best way to connect their new Vaniman sandblaster to their air supply. The type of tubing and hardware that is being used dictates the best method of connecting the sandblaster. 1/4” Outer Diameter (OD) Tubing All...
by Kyle Galenza | Aug 27, 2014 | Tech Tips
Moisture: One problem our micro-blasting customers run into, is that their system gets clogged and stops working properly. This can be due to excessive moisture in the system causing the blasting media to form clumps and obstruct media and air. Below is an example of...